| |
 |
 |
 |
|
So far so good |
May 9, 2024 |
| Reviewer:
Zee33 from Pleasant Hills, PA United States
|
|
I haven't done any milling with my Stihl 084av yet but installed decently. I took my time to prevent debris from getting into the lower end . One issue I did have was the holes in the fins were a little small to use a #25 torx 6"bit so had to drill them out a bit other than that install went good. Make sure you buy a gasket though because the kit doesn't come with one . Carb tuning will be necessary due to the locations of porting . I'm very satisfied with HL Supply. I will be ordering from them again .
Was this review helpful to you? 
|
|
 |
|
 |
|
