Return to Non-Genuine Flywheel Puller (22mm Thread) For Stihl

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 3

0 of 0 people found the following review helpful:

November 24, 2023 Reviewer: John Fitzgerald from Moultonborough, NH United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

March 7, 2023 Reviewer: Joseph Kovach from Greensboro, PA United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

November 25, 2022 Reviewer: Duane Dodde from Falmouth, MI United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Flyway puller October 26, 2022 Reviewer: Charles Mitch from Mequon, WI United States   Works as it should. Was this review helpful to you?

0 of 0 people found the following review helpful:

Just what I needed July 14, 2022 Reviewer: Alfred Joyal from Marquette, MI United States   Perfect foir my need Was this review helpful to you?

0 of 0 people found the following review helpful:

December 11, 2021 Reviewer: ron verhoeven from kerkrade, limburg Netherlands   Doesnt fit on a ms200t but it says in discription that it does fit Was this review helpful to you?

0 of 0 people found the following review helpful:

Stihl flywheel puller November 17, 2021 Reviewer: William Spencer from Huntington, WV United States   Worked great, very good quality and prompt shipping Was this review helpful to you?

0 of 0 people found the following review helpful:

puller January 28, 2021 Reviewer: robert spencer from oxford, NC United States   have not used yet--looks good though Was this review helpful to you?

0 of 0 people found the following review helpful:

Fast shipping December 4, 2020 Reviewer: Christopher Thompson from POUGHKEEPSIE, NY United States   Looks to be a good piece Was this review helpful to you?

0 of 0 people found the following review helpful:

Could be improved September 24, 2020 Reviewer: Jeff from Frewsburg , NY United States   The body screws into the flywheel with no issues, the hole for the push bolt is not drilled true to the axis. Wish the bolt was made with a finer thread count. I may try to correct the hole and change the bolt Was this review helpful to you?