|
![](/v/vspfiles/templates/hls2021/images/RBox_Border_Left_Top.gif) |
![](/v/vspfiles/templates/hls2021/images/clear1x1.gif) |
![](/v/vspfiles/templates/hls2021/images/DBox_Border_Right_Top.gif) |
![](/v/vspfiles/templates/hls2021/images/clear1x1.gif) |
So far so good |
May 9, 2024 |
Reviewer:
Zee33 from Pleasant Hills, PA United States
|
|
I haven't done any milling with my Stihl 084av yet but installed decently. I took my time to prevent debris from getting into the lower end . One issue I did have was the holes in the fins were a little small to use a #25 torx 6"bit so had to drill them out a bit other than that install went good. Make sure you buy a gasket though because the kit doesn't come with one . Carb tuning will be necessary due to the locations of porting . I'm very satisfied with HL Supply. I will be ordering from them again .
Was this review helpful to you?
|
![](/v/vspfiles/templates/hls2021/images/clear1x1.gif) |
![](/v/vspfiles/templates/hls2021/images/DBox_Border_Left_Bottom.gif) |
![](/v/vspfiles/templates/hls2021/images/clear1x1.gif) |
![](/v/vspfiles/templates/hls2021/images/DBox_Border_Right_Bottom.gif) |
|